The Inlock® Fastener is an effective means of anchoring a thread stud into a tube.
The method employed for assembly is to screw two or more inlocks on to a stud and then to press this assembly into the tube leaving a threaded portion protruding. The number of inlocks used is dependent upon the load requirements, but a minimum of two, suitably spaced, must be used to align the stud with the bore of the tube.
Uncapped fasteners are available in:
- Blue and varnish finish for inch BV sizes
- Bronze and varnish finish for metric BV sizes
- Mechanical zinc plated DT finish
- Certain sizes of fasteners are available in stainless steel
We can develop any inlock® to suit any thread size & outer diameter, these will be subject to minimum order quantities.
|Screw Size||Part No.||Tube Size||Outside Diameter||Material Thickness||Remarks|
|M4||8200||5/8" O/D x 18g||.538||.012||helix plug washer|
|3/16"||7084||3/4" O/D x 18g||.670||.016||helix plug washer|
|3/16"||7090||1" O/D x 16g||.900||.016||helix plug washer|
|1/4"||7091||3/4" O/D x 18g||.670||.016||helix plug washer|
|1/4"||7081||7/8" O/D x 16g||.786||.016||helix plug washer|
|1/4"||7083||7/8" O/D x 18g||.805||.016||helix plug washer|
|1/4" plain shaft||7097||3/4" O/D x 18g||.663||.012||plain plug washer|
|1/4" plain shaft||7085||7/8" O/D x 18g||.850||.012||plain plug washer|
|6mm||7099||1" O/D x 16g||22.9mm||.016||helix plug washer|
|5/16"||7082||7/8" O/D x 16g||.786||.016||helix plug washer|
|5/16" plain shaft||7092||5/8" O/D x 18g||.538||.012||plain plug washer|
|5/16" plain shaft||7096||3/4" O/D x 18g||.663||.012||plain plug washer|
|All dimensions shown are in inches unless otherwise stated and are subject to engineering tolerances.|
Please email sales for more information.